Next Post - Previous Post       List View



9/28/2015 6:01:09 PM

How to Grill Wall... Maybe.



While I would like to say this is a "How To", I am reluctant to say so when I don't know how long (or short) this grill wall will last in the outdoor weather.

My poor sanding job of the panels meant that I needed to remove and replace them with some multi-coat pre-varnished panels... which isn't easy with just one person.  Some creative help from an old 2x6 that was laying around and some clamps got it done though.

 
 

So the "privacy wall" portion was complete and hopefully will weather better than the poorly sealed panels did.

And on to the heat-shield/grill wall.  It isn't surprising that there are not many "wall" or "fence" surfaces that are designed to withstand heat without warping or catching on fire.  And since a good portion of this project is so that the grill can be close to the wall for wind and weather protection, I decided to go with indoor/outdoor cement board.

 

And here is where the first "If I did it again, I would..." moment happened.  I should have put support boards behind the sides and seams but didn't think about it, and now it would be too much work to get the cement boards back off and re-do it.  I am not sure if it would have prevented the coating from cracking at the seams, but it definitely would have given the cement board some better structural support.  In any case, I didn't and may live to regret it.

 

The second "I should have...", was that I should have gone ahead and gotten the expensive little bottle of adhesive enhancer type product to mix with the thin-set mortar.  I think it would have given the finish a stronger sticking power.  Without it and using the cheapest thin-set, left the surface pretty easy to brush off a lot of the sandy grit.

 

I am however, very happy with the texture.  I used the wide putty knife and swiped the thin-set on in the seams, then with strokes in all directions to cover the whole surface.  The result was a nice random pattern that looks great.

 
 

I covered the "wall" for the night and was sad to find small cracks along the seams in the morning.  I added another coat along the seams and increased the texture in several places that needed it and hoped for the best, but the cracks over the seams still came back a little the next day.

 
 
 

Four heavy coats of waterproofing sealer did help harden and make the thin-set stronger so it doesn't brush off the grit as easily, and hopefully it will make it last through the weather, though I will probably need to reapply the sealant each year to keep it in good condition.

 

Despite the small cracking at the seams, the sealant should help keep the wall looking nice, and as importantly, I added a galvanized metal trim piece to the top to prevent moisture and snow from soaking in while it sits on the edge.  The trim is sealed with caulk around the top and the sides are caulked with a small bead as well.

 

Now... if only I could figure out how to move the old glass door panels out of the way and put in a bench or maybe a brick-sided stone counter top.  And I also need to figure out a good way to hang or install some lights for grilling in the evening.

LOL... even when "done" the projects continue. Wink




     POST LINKS BACK TO:
          9/13/2015 2:36:35 PM - Project ADD


Next Post - Previous Post       List View
COMMENTS

9/29/2015 11:34:25 AM Punkin
I have never heard of cement boards or any of the stuff you used for this project. Shoulda - Coulda - Woulda! the support boards was an after thought and probably a good one but if I know you if the wall doesn't meet your expectations in the spring you will do something different anyway. And if it holds because it looks like it will then the extra step didn't need to be done anyway.
You get my drift LOL
Beautiful wall!!

9/29/2015 12:06:31 PM TinkerT
Both cement board and thin-set are used for tiling, so they are not something you run into normally.  Hopefully it will last a good long time, but you are right... if it doesn't I will do something different if it fails.

Add Your Comment...

TinkerT Terms & Disclaimer


     Step one to DIY is safety. Use applicable safety equipment, read instructions, and handle all tools with care. While this site encourages a Do-It-Yourself attitude and has ideas and how-to posts, it is not responsible for any problems that arrise from attempting similar DIY projects.
     Familyweb.us and TinkerT makes no representations or warranties of any kind (expressed or implied) about the completeness, accuracy, reliability, suitability, or gramatical correctness of any information or recomendations contained on this site or found by following any link on this site. All the information provided on TinkerT is for general information and entertainment purposes only. Following any advice or information on this site is done "At Your Own Risk". Under no circumstances will Familyweb.us or TinkerT be liable for any loss or damage (including without limitation direct, indirect, or consequential loss or damage) arising from use or misuse of information provided in this website.
     Copyright Policy - Unless otherwise noted, Familyweb.us is the legal copyright holder of all material on this website. Submitions and comments will be considered the property of Familyweb.us and may be used, whole or in part, for purposes on the site or other related projects. Please feel free to copy and reprint any portion of the articles and posts on this site. However, you must include a clear label for where you got the material and include a link to the appropriate page for the post that material was copied from.
     The opinions expressed by any Third Parties (including commenters) are their own and do not represent the position or believe of Familyweb.us or TinkerT. TinkerT reserves the right to remove or edit comments for any reason deemed nessesary, including, but not limited to: spam, offensive language, inapropriatness, and general rudeness.
     TinkerT will never sell or share your email with any third party and will not send you advertizements or spam.
     Familyweb.us and TinkerT reserve the right to change the focus of, close, or sell this blog site without warning.

     While TinkerT and Familyweb.us strive to ensure all posts and comments are PG13 or less, it makes no guarantees of this and requests that anyone under 17 ask their parent's permission before signing up for the newsletter or reading this site.

     These terms and conditions are subject to change at anytime without notice.












aquariums
archives
cooking
crafts
denver
DIY
electronics
home improvement
ideas
landscaping
low budget
mountain living
nature
outdoor
painting
plants
style
the tilt
tools
travel
woodworking

instant pot
  smart scripts