A2 Hosting still has not fixed the Database after their servers failed AGAIN. A2 Hosting is the WORST!
Because of this, new posts are currently missing and I can only HOPE they eventually recover the table they didn't restore after their latest failure.












Next Post - Previous Post       List View



9/18/2016 12:33:08 PM

Not Shocking but a Little Bloody.



While the weather was mostly agreeable, I got the workshop interior insulated and the foam-board up for the ceiling.

 

None of which is fun, but I was very careful to wear a disposable long-sleeved shirt, hat, gloves, safety glasses, and a good quality breather to prevent self-damage from a whole lot of fiber-glass dust.   I was less careful about some spray foam and ended up with it stuck in my hair and rolling down the sliding glass door like a wall-slap toy from the 80's, leaving tracks of impossibly sticky foam behind.  Not a smart idea.  I was able to remove the foam from the glass right away with a bunch of acetone (fingernail polish remover), but for my hair, I had to wait for it to fully cure and then scrape and pull my hair out of it.

After the foam disaster, I got smart and used some cardboard supports and drip catchers to get more foam where it needed to go.

 

Then I got the OSB walls up.  And despite taking a few days to complete, it was mostly pretty easy.  The super special cuts for the ends were annoying though, and I ran out of screws the right size and type, so many of the panels are up with just the minimum and will need more screws later.

 
 

However, after already scraping and denting the foam-board ceiling several times, I decided that I had better get OSB up there as well before I seal and paint everything.  Of course, I didn't have the right size screws, so it had to wait and will hopefully get done this coming week.

While the walls went up with relative ease, I was surprised to find that the electrical, that I thought would be a complete breeze, was MUCH harder than I expected.  Thick 12 gauge wire made for difficult bending back into boxes, and despite using all the special tactics for proper wire installation... like zig-zagging the wires so they would go in easily... nothing was easy about it.

Worse yet, was the junction at the far end of the workshop where many wires needed nutted together and after a couple attempts, and a fingertip sliced neatly open with a razor cutter, I realized that there was simply no possible way those wires would fold and fit into the double-box... let alone with a bunch of big wire-nuts all over.

 

Impressively enough, and not counting some bruises and major soreness, this is my very first real injury on this project.  Unfortunately the location made it very hard to band-aid together and once it scabbed a little I have been holding it closed with super-glue and wishful thinking.

So work screeched to a halt on Friday, and Saturday was spent in town getting screws and special electrical stuff.  I feared that I would need to put in two four-gang boxes to fit all those wires and nuts, but with some special push-connectors and an extra-deep three-gang box, everything fit without problems.  (Those push-connectors are really nice by the way and I went back to several other spots and replaced nuts with them.)

 

And now the happy report of electricity!  Plugs powering, switches switching, and junctions.... er.... junctioning?

If I were running at full speed, I would now be cutting the OSB for the ceiling and figuring some kind of complex system of braces to get it up there... but I am definitely slowing down and not running at top speed.  Of course, I got the wall primer and floor paint on Saturday, too, so getting the ceiling OSB done is pretty high on the list of "Get-er-done".  Ummmmm..... tomorrow.


     POST LINKS FORWARD TO:
          9/29/2016 9:29:09 AM - Two months later... and the shed is OFFICIALLY DONE.
     POST LINKS BACK TO:
          9/10/2016 8:25:46 AM - Just in Time!


Next Post - Previous Post       List View
COMMENTS

9/18/2016 1:54:54 PM Punkin
WOW! I know how that cut hurt because I been there and did that. No fun atoll!!
All the other things you have done are as always amazing. I would never have undertaken the  electrical part of any project. I don't even plug something into the wall if I can get someone else to do it. 
(I was electrocuted once, being barefoot on a concrete garage floor and grabbed a huge deep freezer handle before my dad has gotten it grounded. The shock threw me from the front of the garage to the rear and I couldn't get up) Any way I have a great respect for the work you do.

9/19/2016 8:21:31 AM TinkerT
Wow!  That kind of electrical hit would not be fun at all.  I have gotten shocked a couple times over the years, but nothing serious.

9/19/2016 8:22:25 AM WA Mom
You are looking really skinny. Hope you are taking good care of yourself. I can not believe the amount of work you are doing by yourself. You are amazing.

9/19/2016 8:22:49 AM TinkerT
Some one else said skinny, too.  I have lost a little weight in all this, but not much.  I think I am just getting better taking photos from a skinny angle.  LOL

9/19/2016 8:23:27 AM Mom
Good job on the electric! You are getting so close. It is turning out really nice. Lol on the dreams, I can't even imagine all the dew hickies you could put on the walls.

9/21/2016 4:40:13 PM Crash
at least you used white spray foam, I used bright orange and yes it sticks to hair, shirt, face, pants, and gloves

9/21/2016 4:40:33 PM TinkerT
LOL... Yeah... the bad part was... I know better from getting it stuck to my arm and an old coat once, too.  Easy to forget I guess though.

Add Your Comment...


Please Keep All Comments Family-Friendly

Name / Nickname:  
Comment:  
Email:   (Optional)
      Notify me of new Comments/Replies to this post by email
      Remember my Email for future comments
Your Email is Never Shared. Email is only required if you want to be notified
of new comments or if you are entering a give-away.


Please Type This Verification Code:   k4nz8k    (Code is case sensitive.)


TinkerT Terms & Disclaimer


     Step one to DIY is safety. Use applicable safety equipment, read instructions, and handle all tools with care. While this site encourages a Do-It-Yourself attitude and has ideas and how-to posts, it is not responsible for any problems that arrise from attempting similar DIY projects.
     Familyweb.us and TinkerT makes no representations or warranties of any kind (expressed or implied) about the completeness, accuracy, reliability, suitability, or gramatical correctness of any information or recomendations contained on this site or found by following any link on this site. All the information provided on TinkerT is for general information and entertainment purposes only. Following any advice or information on this site is done "At Your Own Risk". Under no circumstances will Familyweb.us or TinkerT be liable for any loss or damage (including without limitation direct, indirect, or consequential loss or damage) arising from use or misuse of information provided in this website.
     Copyright Policy - Unless otherwise noted, Familyweb.us is the legal copyright holder of all material on this website. Submitions and comments will be considered the property of Familyweb.us and may be used, whole or in part, for purposes on the site or other related projects. Please feel free to copy and reprint any portion of the articles and posts on this site. However, you must include a clear label for where you got the material and include a link to the appropriate page for the post that material was copied from.
     The opinions expressed by any Third Parties (including commenters) are their own and do not represent the position or believe of Familyweb.us or TinkerT. TinkerT reserves the right to remove or edit comments for any reason deemed nessesary, including, but not limited to: spam, offensive language, inapropriatness, and general rudeness.
     TinkerT will never sell or share your email with any third party and will not send you advertizements or spam.
     Familyweb.us and TinkerT reserve the right to change the focus of, close, or sell this blog site without warning.

     While TinkerT and Familyweb.us strive to ensure all posts and comments are PG13 or less, it makes no guarantees of this and requests that anyone under 17 ask their parent's permission before signing up for the newsletter or reading this site.

     These terms and conditions are subject to change at anytime without notice.












aquariums
archives
cooking
crafts
denver
DIY
electronics
home improvement
ideas
landscaping
low budget
mountain living
nature
outdoor
painting
plants
style
the tilt
tools
travel
woodworking

instant pot
  smart scripts