A2 Hosting still has not fixed the Database after their servers failed AGAIN. A2 Hosting is the WORST!
Because of this, new posts are currently missing and I can only HOPE they eventually recover the table they didn't restore after their latest failure.












Next Post - Previous Post       List View



11/8/2014 11:39:51 AM

Septic Effluent Filter



Last Sunday hubby and I dug up the lids to our septic tank, removed a clog near the entrance, and attempted to test the levels to see if it needed pumped or not.  In doing so, I looked up some information on testing septic tanks, and found that an effluent filter at the drain side of the tank could greatly improve the life-time and functioning of our drain-field.

So I ordered one from the Home Depot and it arrived yesterday (much earlier than expected) so we were happily able to get it installed today and the septic tank lids re-covered.

I started by putting on disposable gloves, then using a cheap old trowel to remove gunk and grime from around the drain pipe.

 

Then I carefully hammered on the inner fitting from the filter housing to the drain pipe.  
 

I had hubby lower the filter with a strap to be sure it didn't slip and fall all the way into the tank as I got it placed and on the pipe fitting.  Tapped it into place with the dead-blow hammer and then drilled a pilot hole and screwed in a long stainless steel screw to be sure it doesn't slip off over time.

 

I am very sure this should have been done by draining the whole tank, cleaning it to sparkling clean and then gluing on the fitting with PVC glue and then probably gluing the filter to the fitting.  However, not having the time, the pump truck, or any other way of draining the tank... not to mention a complete lack of any directions at all with the filter... it will have to suffice to have a hammered on fitting and a stainless steel screw to be sure it stays in place.



And then it was time to re-fill the holes over the lids.  I previously used a half-barrel as a planter to mark and half-fill the holes, but the side with the rim was more trouble to dig up than benefit, so I decided to try some empty cat-litter buckets to partially fill the hole.  They will have enough dirt on top and below them to keep any sewer gasses from coming up, but be easy to pull out of the ground and reduce digging by a little more than half.  Only time will tell if it is a good idea, but since I can't afford septic tank risers at this time, I hope it will at least help a little on the next time we have to dig things up.

 





     POST LINKS FORWARD TO:
          9/24/2015 12:00:38 PM - Septic Saga
     POST LINKS BACK TO:
          11/4/2014 12:47:18 PM - Sunday Septic Fun and How to Tell If Your Tank Needs Pumped


Next Post - Previous Post       List View
COMMENTS

11/8/2014 1:02:47 PM Punkin
Fantastic work!!!

Add Your Comment...


Please Keep All Comments Family-Friendly

Name / Nickname:  
Comment:  
Email:   (Optional)
      Notify me of new Comments/Replies to this post by email
      Remember my Email for future comments
Your Email is Never Shared. Email is only required if you want to be notified
of new comments or if you are entering a give-away.


Please Type This Verification Code:   il9sbl    (Code is case sensitive.)


TinkerT Terms & Disclaimer


     Step one to DIY is safety. Use applicable safety equipment, read instructions, and handle all tools with care. While this site encourages a Do-It-Yourself attitude and has ideas and how-to posts, it is not responsible for any problems that arrise from attempting similar DIY projects.
     Familyweb.us and TinkerT makes no representations or warranties of any kind (expressed or implied) about the completeness, accuracy, reliability, suitability, or gramatical correctness of any information or recomendations contained on this site or found by following any link on this site. All the information provided on TinkerT is for general information and entertainment purposes only. Following any advice or information on this site is done "At Your Own Risk". Under no circumstances will Familyweb.us or TinkerT be liable for any loss or damage (including without limitation direct, indirect, or consequential loss or damage) arising from use or misuse of information provided in this website.
     Copyright Policy - Unless otherwise noted, Familyweb.us is the legal copyright holder of all material on this website. Submitions and comments will be considered the property of Familyweb.us and may be used, whole or in part, for purposes on the site or other related projects. Please feel free to copy and reprint any portion of the articles and posts on this site. However, you must include a clear label for where you got the material and include a link to the appropriate page for the post that material was copied from.
     The opinions expressed by any Third Parties (including commenters) are their own and do not represent the position or believe of Familyweb.us or TinkerT. TinkerT reserves the right to remove or edit comments for any reason deemed nessesary, including, but not limited to: spam, offensive language, inapropriatness, and general rudeness.
     TinkerT will never sell or share your email with any third party and will not send you advertizements or spam.
     Familyweb.us and TinkerT reserve the right to change the focus of, close, or sell this blog site without warning.

     While TinkerT and Familyweb.us strive to ensure all posts and comments are PG13 or less, it makes no guarantees of this and requests that anyone under 17 ask their parent's permission before signing up for the newsletter or reading this site.

     These terms and conditions are subject to change at anytime without notice.












aquariums
archives
cooking
crafts
denver
DIY
electronics
home improvement
ideas
landscaping
low budget
mountain living
nature
outdoor
painting
plants
style
the tilt
tools
travel
woodworking

instant pot
  smart scripts